Abstract The effectiveness of at-home dental bleaching treatments depends on the time that bleaching products are in contact with the teeth surface and, consequently, on the adequate use of associated custom acetate trays. Objective This randomized single-blinded trial aimed to analyze if the daily usage time of these products influences the patient’s compliance behavior when submitted to monitored at-home dental bleaching. Secondary outcomes were color change and tooth sensitivity. Methodology Sixty-six volunteers were randomly distributed into three groups (n=22): patients were instructed to use the trays for 2 (G2), 4 (G4), and 8 (G8) hours daily. The daily dental bleaching compliance behavior was measured using a microsensor inserted into the trays. Subjective and objective color evaluation assessments were adopted at baseline (T0), one (T1), two (T2), and three weeks (T3) after the beginning of the bleaching treatment, as well as two weeks after the treatment (T4). Tooth sensitivity was analyzed using the VAS scale, ranging from T1 to T4. Results G2 showed a greater degree of cooperation than G8 and cooperation was inversely proportional to the recommended usage time. Significantly higher color change was observed in the upper arch for G8 when compared to G2 in subjective analysis, from T1 to T4. There were no statistical differences between the groups in objective analysis. Conclusion Shorter recommended usage time of the bleaching product may improve the patient's compliance with at-home dental bleaching treatments. However, increased daily usage time may promote better subjective color change. Bleaching sensitivity was more significant in the first week for a longer time of use.

ABSTRACT Objective: To investigate the tissue response and the biomineralization ability of CER prepared with epoxy resin or water compared to Mineral Trioxide Aggregate (MTA). Material and Methods: Polyethylene tubes containing materials or empty tubes for control were inserted into the subcutaneous tissues of 30 rats. After 7, 15, 30, 60, and 90 days, the rats were killed and the tubes were removed for analysis using hematoxylin-eosin staining, von Kossa staining, and under polarized light. Inflammation was graded through a score system; the thickness of the fibrous capsule was classified as thin or thick; the biomineralization ability was recorded as present or absent. The results were statistically analyzed using the Kruskal-Wallis test (p<0.05). Results: Histologic analysis performed after 7 and 15 days for CER prepared with epoxy resin or water and for MTA showed moderate inflammation and a thick fibrous capsule (p>0.05). After 30, 60, and 90 days, mild inflammation, and a thin fibrous capsule were observed in all groups (p>0.05). Conclusion: All materials had structures positive for von Kossa and birefringent to polarized light. CER epoxy resin showed biocompatibility and biomineralization similar to CER water and MTA.

OBJETIVO: a proposta desse estudo foi avaliar, por meio de microscopia eletrônica de varredura (MEV), a interface adesiva após a descolagem de acessórios ortodônticos, fixados em dentes bovinos com emprego de adesivo hidrofílico e hidrofóbico, em condições distintas de umidade do substrato dentário. MÉTODOS: foram utilizados 20 incisivos inferiores, divididos em quatro grupos (n = 5): Grupo I , empregou-se o sistema de colagem contendo o primer hidrofílico Transbond MIP e a pasta adesiva Transbond XT, aplicados em substrato úmido; Grupo II, empregou-se o sistema de colagem primer hidrofóbico Transbond XT e pasta adesiva em substrato úmido; Grupos III e IV, os braquetes foram colados com os mesmos sistemas de união dos Grupos I e II, porém com esmalte dentário seco. Removidos os acessórios, avaliou-se em MEV, em diferentes magnificações, a interface adesiva e a interação dos sistemas adesivos com o esmalte dentário. As imagens foram avaliadas qualitativamente, observando-se o embricamento mecânico para o adesivo hidrófilo em quaisquer condições de substrato. RESULTADOS: a falta de umidade no esmalte condicionado permitiu uma melhor interação entre os materiais de ligação e a estrutura adamantina. O adesivo hidrofóbico apresentou o pior resultado de interação micromecânica quando aplicado a uma estrutura dentária úmida; já o sistema hidrofílico mostrou-se versátil, obtendo resultados aceitáveis em condições de umidade e excelente interação na ausência de contaminação. CONCLUSÃO: os autores afirmam que a melhor condição do esmalte dentário para a aplicação de primers é com a ausência de umidade.

OBJECTIVE: The purpose of this study was to assess by means of scanning electron microscopy (SEM) the remaining adhesive interface after debonding orthodontic attachments bonded to bovine teeth with the use of hydrophilic and hydrophobic primers under different dental substrate moisture conditions. MATERIAL AND METHODS: Twenty mandibular incisors were divided into four groups (n=5). In Group I, bracket bonding was performed with Transbond MIP hydrophilic primer and Transbond XT adhesive paste applied to moist substrate, and in Group II a bonding system comprising Transbond XT hydrophobic primer and adhesive paste was applied to moist substrate. Brackets were bonded to the specimens in Groups III and IV using the same adhesive systems, but on dry dental enamel. The images were qualitatively assessed by SEM. RESULTS: The absence of moisture in etched enamel enabled better interaction between bonding materials and the adamantine structure. The hydrophobic primer achieved the worst micromechanical interlocking results when applied to a moist dental structure, whereas the hydrophilic system proved versatile, yielding acceptable results in moist conditions and excellent interaction in the absence of contamination. CONCLUSION: The authors assert that the best condition for the application of primers to dental enamel occurs in the absence of moisture.

OBJETIVOS: determinar a morfologia das 3ª e 4ª vértebras cervicais representativa dos estágios de pré-pico, pico e pós-pico de velocidade de crescimento estatural, definidos previamente pelos centros de ossificação do primeiro dedo em radiografias carpais ou do dedo polegar. MÉTODOS: foram utilizadas 120 telerradiografias em norma lateral de 106 pacientes selecionados da clínica de Ortodontia Preventiva e Interceptiva da Faculdade de Odontologia de Araçatuba-UNESP e Profis/HRAC-USP que apresentavam as correspondentes radiografias carpais ou do dedo polegar. As telerradiografias foram divididas em três grupos de 40 radiografias, de acordo com os estágios maturacionais pré-pico, pico e pós-pico, definidos pela imagem do primeiro dedo. A morfologia dos corpos das 3ª e 4ª vértebras cervicais foi determinada por dois examinadores devidamente calibrados em dois tempos diferentes. CONCLUSÕES: concluiu-se que o formato retangular horizontal com borda inferior reta foi representativo do estágio de pré-pico, independentemente da vértebra analisada. Já o formato retangular horizontal com borda inferior curva, especialmente se encontrado em C4, ou o formato quadrado com borda inferior reta caracterizaram o pico de velocidade de crescimento. O formato quadrado ou, principalmente, o retangular vertical com borda inferior curva determinaram o estágio de pós-pico de velocidade de crescimento da adolescência.

AIM: To determine the morphology of the third and fourth cervical vertebrae which represent the pre-peak, peak and post-peak stages of statural growth, previously defined by ossification centers of the thumb in hand-wrist or thumb periapical radiographs. METHODS: The sample was comprised of 120 lateral cephalometric radiographs of 106 patients from the Interceptive Orthodontics Clinic of the School of Dentistry of Araçatuba/UNESP and from PROFIS /Hospital for Rehabilitation of Craniofacial Anomalies/USP. All patients had hand-wrist or corresponding thumb periapical radiographs available. The lateral radiographs were divided into three groups of 40 radiographs according to the pre-peak, peak and post-peak maturational stages, defined by the radiographic image of the thumb. The morphology of the third and fourth cervical vertebrae was determined by two calibrated examiners in two different times. CONCLUSIONS: The findings show that the horizontal, rectangular-shaped vertebra with straight lower border represented the pre-peak stage, regardless of the analyzed vertebra. The horizontal, rectangular-shaped vertebra with curved lower border, mainly if found in C4, or the square-shaped vertebra with straight lower border was typical of the growth peak. The square-shaped or, mainly, the rectangular-shaped vertebra with curved lower border determined the post-peak stage of adolescent growth spurt.

OBJETIVO: o presente ensaio científico põe em pauta o efeito imediato da distalização unilateral de molares superiores, lançando mão do distalizador intrabucal Pendex de ação unilateral. METODOLOGIA: o estudo prospectivo foi conduzido em três pacientes na dentadura permanente madura, no estágio de adolescência, que apresentavam uma má oclusão Classe II, subdivisão. O aparelho Pendex foi instalado com a mola distalizadora de TMA, construída apenas no lado direito. A metodologia baseou-se nas radiografias panorâmicas inicial e pós-distalização para quantificar a inclinação axial mesiodistal dos molares superiores. RESULTADOS E CONCLUSÕES: os resultados mostraram que os molares do lado esquerdo mantiveram sua inclinação mesiodistal inicial, sugerindo ancoragem, enquanto os molares do lado direito foram inclinados para distal, à semelhança do que ocorre com a distalização simétrica dos molares superiores, obtida com o aparelho Pendex convencional. Os primeiros molares foram inclinados 11,5º, enquanto os segundos molares foram inclinados 21º para distal.

AIM: the current study focuses on the immediate unilateral distalization of the upper molars with the unilateral Pend-X appliance. METHODS: in three adolescent patients in the permanent dentition with Class II subdivision 1 malocclusion, the TMA loop was placed in the right side. Therefore, the first and second upper right molars were distalized with the Pend-X appliance. Panoramic radiographs taken before and after distalization were used to measure the mesiodistal axial inclination of the upper molars and the results were compared to those obtained with the bilateral Pend-X. RESULTS AND CONCLUSION: the findings show that the left molars kept their original mesiodistal inclination, suggesting that the anchorage was maintained, whilst the right molars were partially inclined in a distal direction, similarly to what occurs when conventional Pend-X is used to distalize molars bilaterally. The first molars showed an 11.5º distal inclination while the second molars presented a 21º distal inclination.